I'm not a pool repair guy. If you have pool questions you should post them in the forums or call a professional. But if you have questions about the website you can send me a message.


Your Email Address:  

Subject: 

Message: 
Did it work? Let us know!
Yes: 88 %       No: 12 %
Peter said...
I am not getting the no cell power message, but am getting "Low volts" and the PPM is 0, Voltage is 0 and the Amps is 0 on the display. I had the cell tested and it was fine. I looked on the back of the board and there is no burn. There is plenty of salt in the pool, maybe event too much. Has anyone run into this particular error message?
Steve said...
Thank you so much. Five minute fix, zero dollars.
chuck said...
Just sent my donation. I had previously studied this a bit and spent less than 15 minutes on the fix today when I got the error. Leave the board in.
Disclaimer: Following these instructions could lead to expensive pool repairs, electrocution, and death. Use at your own risk.
©2010 NoCellPower.com